Email:info@hnwbzn.com
  Tel      : +86-37155275585
Media center
You are here: Home » News » Company news » How to Minimize the Rebounding of Shotcrete Machine

News recommendation

Recommendation product

How to Minimize the Rebounding of Shotcrete Machine

Views:9     Author:Site Editor     Publish Time: 2018-07-09      Origin:Site

How to minimize the rebounding of shotcrete machine


Shotcrete, is a wet mix technique that produces a high velocity cone-shaped spray pattern via pneumatic mechanism onto a horizontal or vertical surface. Increase the air from the shotcrete nozzle to increase the velocity and the compaction of the particles and produce a denser concrete. Shotcrete uses either aggregates or mortar.

When to use shotcrete?
When you need to apply concrete vertically but do not want to deal with formwork and poured in concrete. Shotcrete works best for covering or repairing curved surfaces like swimming pools, bridges, tunnels, dams, slope reinforcement…

Strength of Shotcrete
Shotcrete uses a wet mix so the water/concrete ratio is very important and controlled by the nozzle man. It needs to be low (under 0.5) to obtain a denser and water-resistant mix.  This will also help reduce shrinkage and lower permeability in the finished product.

What is rebound?
One of the problems with shotcrete is the loss of material from concrete ricochets off the target surface due to the high velocity of the spray. This causes having to use more concrete, longer application times etc. The result can be vastly different when it comes to the properties of the in-placed concrete mix. If you use steel fibers as a distribution solution, the problem is even more problematic than with aggregates. According to Austin and Robins (1995), aggregates rebound is about 20-30% whereas with steel fibers, rebounding can reach 35-78% (Morgan et al., 1987; Banthia et al., 1992) with dry-mix shotcrete. With such high rebound, compaction is reduced and the concrete strength ends up greatly compromised.  The rebound of non-adhering material during a gunite operation (using a dry process) is greater than during a shotcrete job (wet process) because gunite requires a much larger air compressor. On a gunite job, the rebound material can be reused, whereas, on a shotcrete job, the non-adhering material is wasted. Removing it is time consuming, slows progress and can be costly. So choosing the right technique for the job is essential.

Thick or thin applications?
It turns out that the percentage of loss is affected by the thickness of the layer sprayed. In other words, the thinner the layer of shotcrete, the larger the percentage loss. The highest amount of rebound happens in the first spray on concrete. With subsequent coats, rebound diminishes. Another factor affecting the rate of rebound is aggregate density. A lower density will result in lower rebound rate.

What shotcrete machine is best for your job?
 If you are not sure what concrete shotcrete machine is best for your next job, consult our technical manager at
+86-155 1589 8077. With over 20 years experience in all things concrete, no question is too simple or too complex for him!

Some great shotcrete machines he recommends are:

Wet Mix Concrete Spraying Shotcrete Machine HS700

Truck-mounted Shotcrete Machine with Automatic Feeding System HS600/700*2






Product
Contact
  Tel: +86 371 55275585
  Whatsapp: +86 13526650911
  Email: info@hnwbzn.com
    Address: Enterprise Headquarters Base 87,Zhengzhou High-Tech Development Zone,Zhengzhou,China.
 
Inquiry

Copyright © Henan Weibang Intelligent Science & Technology Co., Ltd.